Cadillac 2008 escalade esv Uživatelský manuál

Overview... 1-1Overview... 1-2Features and Control

Entering an Address and Point ofInterest, and Storing PresetDestinationsEntering an AddressTo enter a destination by inputting the city name first,do t

See “Address Entry ” under Destination on page 2-13for more information.Entering a Point of Interest (POI)To set a destination by entering a Point of

6. Press the DEST hard key, the Route screen willdisplay. Press the Final Destination or Stopoverscreen button. The information screen will displayfor

Canceling GuidanceGuidance will be canceled once you arrive at your finaldestination. To cancel guidance prior to arrival at thefinal destination, do th

✍ NOTES1-12

Features and Controls ...2-2Using the Navigation System ...2-2Maps ...

Features and ControlsUsing the Navigation SystemThis section presents basic information needed tooperate the navigation system.Use the hard keys locat

5 (Phone): Press this key to access calling throughOnStar®. See Phone on page 5-2 for more information.See “OnStar®System” in the Index of your vehicl

0-9 (Numbers): Select this screen button to selectnumbers.U (Space): Select the space screen button to entera space between characters or the words of

Installing the DVD Map DiscYour dealer/retailer may have installed the map DVD. Ifthe map DVD was not installed, do the following to load it:1. Turn t

GENERAL MOTORS, GM, the GM Emblem, CADILLAC,the CADILLAC Crest & Wreath, the names Escalade,Escalade/ESV, and EXT are registered trademarksof Gene

Map AdjustmentsThe system allows you to adjust the scale of view onthe map. Also, as you drive, the map will scrollautomatically based on the directio

SymbolsThe following symbols are the most common symbolsthat will appear on a map screen.Your vehicle is shown asthis symbol. It indicates thecurrent

The distance and time todestination symbolindicates the distance andthe estimated timeremaining to your finaldestination, depending onthe option select

Three-dimensional (3–D) view mode will change theappearance of the map display to a road level view.The No GPS symbolwill appear when yourvehicle is a

Select one of the POI categories to display or to deletePOI icons from the map screen. Once a categoryhas been selected the POI icon will display at t

Address Book: Press this screen button to add thisPOI to the address book. See “Nav” under ConfigureMenu on page 2-28 for information on editing addres

When you are approximately 1/4 mi (400 m) from thenext maneuver, the screen will display the name and adetailed view of the next maneuver.3–D Lane Gui

Dual ModeThis dual screen symbolwill display when thescreen is in dual mode.Dual mode displays the route on half of the screen anda maneuver or turn l

To enter a destination by inputting the city name first,do the following:1. Press the DEST hard key.2. Select the2 Address Entry screen button.3. Selec

9. Select the Start Guidance screen button. You arenow ready to start your route.See “Getting Started on Your Route” later in thissection for more inf

Overview ...1-2Navigation System Overview ...1-2Getting Started ...

To enter a destination by entering a cross street, do thefollowing:1. Press the DEST hard key.2. Select the2 Address Entry screen button.3. Select the

Point of Interest (POI)The Point of Interest (POI) destination entry methodallows you to select a destination from the POI list.i Point of Interest: T

To use the point of interest destination entry method byselecting a category, do the following:1. Press the DEST hard key.2. Select thei Point of Inte

To use the address book entry method, do the following:1. Press the DEST hard key.2. Select theg Address Book screen button.A list of your address boo

To use the previous destination entry method, do thefollowing:1. Press the DEST hard key.2. Select the/ Previous Destination screen button.3. Select a

To use this destination entry method, do the following:1. Press the DEST hard key.2. Select the) From Map screen button. A mapscreen will display with

To use the coordinates destination entry method, do thefollowing:1. Press the DEST hard key.2. Select the From Map screen button.3. Select the Map Coo

To use the preset destination entry method, do thefollowing:1. Press the DEST hard key.2. Select the desired preset destination screen button.The scre

r / q (Scroll Arrows): Touch the up and downarrow screen buttons to scroll through the list ofmaneuvers.Avoid: Touch this screen button, next to the a

r / [ (Fast Forward Scroll): Select this screenbutton to scroll to the next stopover or to the finaldestination. Theu (fast forward skip) button willch

OverviewNavigation System OverviewScreen shown with Map Disc Inserted1-2

To add a stopover:1. Press the DEST hard key.2. Select the Add Stopover screen button. This buttonwill only appear if a route has been calculated.3. U

Adding Destinations to theAddress BookThere are two ways to add a destination to theaddress book:• To add the current vehicle position to the addressb

Configure MenuPress the CONFIG (Configure) hard key to adjustseveral of your system’s features and preferences. Thelast selected CONFIG screen will be t

Nav (Navigation)Press the CONFIG key to enter the configure menuoptions, then press the CONFIG key repeatedlyuntil Nav is selected or touch the Nav scr

3. Select the Edit/View Address Book screen button.4. Select the Address book entry.5. Touch the Name screen button and use the alphakeyboard to edit

To delete an address book entry:1. Select the CONFIG hard key.2. Select the NAV screen button.3. Select the Edit/View Address Book screen button.4. Se

Off-Road ModeTo turn the Off-road mode on or off, do the following:1. Press the CONFIG hard key.2. Press the Nav screen button.3. Press the Off-Road m

Brightness/Contrast/ModeTouch this screen button to change the brightness,contrast, and mode of the display.] (Brightness): Touch the + (plus) or − (m

Rear Vision CameraYour vehicle may have a rear vision camera system.Read this entire section before using the camerasystem.The rear vision camera syst

There is a message on the rear vision camera screenthat states “Check Surroundings for Safety”.{CAUTION:The Rear Vision Camera (RVC) system doesnot re

A. FULL MAP Touch Screen Button. See “NAV” under“Hard Keys” under Using the Navigation Systemon page 2-2 for more information.B. No GPS Symbol. See Sy

The following illustration shows the field of view that thecamera provides.Adjusting the Brightness and Contrast ofthe ScreenTo adjust the brightness a

To turn the symbols on or off, do the following:1. Make sure that URPA has not been disabled.2. Shift into PARK (P).3. Press the CONFIG hard key to en

Global Positioning System (GPS)The navigation system determines the position of yourvehicle by using satellite signals, various vehicle signals,and ma

• The current position calibration is set incorrectly.• The vehicle is traveling at high speed.• The vehicle changes directions more than once, orwhen

• Some routes may not be searched.• The route to the destination may not be shown ifthere are new roads, if roads have recentlychanged, or if certain

Navigation Audio System ...3-2CD Player ...3-9DVD Player ...

Navigation Audio SystemNotice: Before adding any sound equipment toyour vehicle, such as an audio system, CD player,CB radio, mobile telephone, or two

Finding a StationIf viewing a map screen, touch the source screen(AM, FM, XM, CD, etc.) button. The display will splitbetween the audio screen and the

Category: Touch the screen button, located in themiddle of the screen, to receive a list of all of theselected band stations in the area. Use the up a

4. Seek, scan, or tune to the desired station, to selectthe station.5. Press and hold one of the preset screen buttons formore than two seconds or unt

T. POI (Point of Interest) Touch Screen Button. See“Displaying Points of Interest (POI) on the MapScreen” under Symbols on page 2-7 for moreinformatio

Select from the following DSP settings:Normal: Select this screen button to adjust the audio tobe in normal mode. DSP will be off.Surround: Select thi

Additional Information DisplayedThe navigation system may have this feature.Touch the Additional Information Displayed screenbutton to turn station, c

the music is much louder than the background noise,there may be little or no adjustments by AudioPilot®.For more information on AudioPilot®, visitwww.

XM™ Radio MessagesXL (Explicit Language Channels): XL on the radiodisplay, after the channel name, indicates content withexplicit language. These chan

Six-Disc CD PlayerWhile playing a CD, the navigation system is available.When you insert a CD, the CD tab will display. Ifyou select a DSP setting for

To load multiple discs, do the following:1. Press and hold the load hard key and follow thescreen message displayed.2. When the system displays “Inser

r (Rewind): Touch and hold this button to rewindquickly through a track selection. You will hear sound at areduced volume. Release this button to stop

• It is recommended that there is a maximum of192 files on a disc.• The files can be recorded on a CD-R or CD-RWwith a maximum capacity of 700MB.• DVD w

Playing an MP3While playing a CD, the navigation system is available.When you insert a CD, the CD tab will display. Ifyou select a DSP setting for the

To load multiple discs, do the following:1. Press and hold the load hard key and follow thescreen message displayed.2. When the system displays “Inser

• Set up your audio by presetting your favoritestations, setting the tone, and adjusting thespeakers. Then, when driving conditions permit, youcan tun

r (Rewind): Touch and hold this button to rewindquickly through a track selection. You will hear sound at areduced volume. Release this button to stop

• There may have been a problem while burningthe CD.• The label may be caught in the CD player.If the CD is not playing correctly, for any other reaso

If an error appears on the display, see “DVD Messages”later in this section.M (Load): To load one disc, do the following:1. Press the load hard key an

O / 3 (Power/Volume): Press this knob to turn thesystem on and off. Turn the knob to increase ordecrease the volume of the audio system.Press and hold

[ (Forward): Touch and release this button toadvance rapidly through the scene, chapters, and titles.Touch this button again to increase the fast forw

Search: Touch this button to display the search screen.Select Title or Chapter Search for DVD video andGroup or Track for DVD audio. The keyboard allo

Audio Language: Touch English, Francais, Espanol,Italiano, or Deutsch to change the default language thatthe DVD player uses for each disc. The audio

z (Previous Track/Chapter): Press this hard key toreturn to the start of the current track or chapter.Press this button again to go to the previous tr

To switch the RSE system to use an auxiliary device,do the following:1. Connect the auxiliary device to the RSE system, forthe second or third row.2.

Voice Recognition ...4-2Section 4 Voice Recognition4-1

The navigation system allows you to do the following:• Plan a route with provided turn-by-turn routeand map guidance with voice prompts.• Select a des

Voice RecognitionThe navigation system’s voice recognition allows forhands-free operation of the navigation system,audio system, and OnStar®features.

• Background noise may cause voice commandsto be misunderstood, including airflow noisefrom wind.• To use the voice recognition system, the mapDVD must

Display [set] night [mode]: Use this command to setthe display to night mode.Display [set] auto [mode]: Use this command to setthe display to automati

Auxiliary CommandsThe following auxiliary commands can be accessed byclearly stating the commands exactly as they arewritten. The commands are availab

✍ NOTES4-6

Phone ...5-2Section 5 Phone5-1

PhoneThe navigation system has a calling feature if you havea subscription for OnStar®personal calling. See theOnStar®manual for more information. Thi

AAdding Destinations to the Address Book ... 2-27Adding or Changing Preset Destinations ... 2-27Alpha-Numeric Keyboard ...

FFinding a Station ... 3-3GGetting Started, Navigation ... 1-4Getting Started

OOrderingMap DVDs ... 2-40Overview, Navigation System ... 1-2Owners, Canadian

Language — English/MetricTo change the language of the navigation screens, see“Driver Information Center, DIC Vehicle Customization”in the Index of yo

TTouch-Sensitive Screen Buttons ....... 2-3UUsing an MP3 CD ........... 3-12Using Your Stored Preset